Let’s learn by doing! In this Part Exercise you will learn the following:1. Extrude2. Sweep3. Sweep Cut4. Circular pattern 5. 3D Sketch6. Hole Wizard7. Trim8...

Performing a simulation for a pair of meshing spur gears. A torque of 15,000 lb-in is applied on the upper gear while both gears are at rest.The aim is to as...

Picture an explosion, while such, an aluminum pipe blasts away due to explosive pressure and hits a solid steel column, deforms, then broken into pieces due to excessive strain. This is demonstrated u

Conducting a thermal analysis of an aluminum heat sink.A fan forces air over all surfaces of the heat sink except for the base, where a heat flux q’ is presc...

Let’s learn SolidWorks by building a Geneva Mechanism Project. In this project we’ll learn how to model parts, assemble these parts, create and output a moti...

In this case study we analyze the maximum deformation and the distribution of von Mises stresses under the given distributed load and boundary conditions:The...

This example simulates the same pipe flow using the k-ω turbulence model in @comsol Multiphysics. The flow conditions are typical to those that can be found ...

Let’s learn by doing! In this Part Exercise you will learn the following:1. Extrude2. Mirror3. Reference Geometry (Planes)4. Circles 5. Trim6. Fillets7. Mate...

A silicon wafer is heated up by a laser that moves radially in and out over time while the wafer itself rotates on its stage. Modeling the incident heat f...

Forward Kinematics : Given or knowing the joint angles, where is the position of the robot end-effector? In other words, Forward kinematics is getting the po...