Our specially designed clothes airer support brackets are exclusive to Cast in Style, PLEASE NOTE SOLD IN SINGLES. We have designed these special brackets to be able to support any of our clothes airers from the wall rather than from the ceiling. They are ideal if you cannot fit our clothes airer pulleys into your ceiling because you have a suspended ceiling or your joists simply are not in the right position for you. They make installing one of our beautiful Kitchen Maid clothes airers now possible and easy to do. Each bracket is supplied with a pulley fixing bolt. Our pulleys have detachable screw rods which you can simply remove and then, using the bolt supplied, attach the pulley to the end of the bracket. You can then mount the brackets to the wall and hang your clothes airer from this. You will need a bracket for each pulley your clothes airer requires. Our clothes airer need a minimum of 2 pulleys so you will need at least 2 brackets, but if you need extra double pulleys you will require a bracket for each of these as well. For this reason the brackets are sold in singles. Small brackets will fit our 3 and 4 lath clothes airers and also our 5 and 7 lath Gismo clothes airer Large Brackets will be required to fit our 5, 6 and 7 lath clothes airers. IMPORTANT: We do not provide screws with the brackets as there are many different types of walls and each requires different fixings. As a "general" guide to help you we suggest some fixings below, but please consult your builder for your type of wall. Brick Walls - Use Rawl Bolts. These are metal bolts with a metal expansion cage located into the wall and are easily available from DIY stores. Plaster Board Walls - we STRONGLY recommend you use good cavity fixing screws to properly hold the weight of the bracket to a cavity wall. As an excellent alternative a fixing called "Gripit" can be used and are available at their web site www.gripitfixings.co.uk and good on-line retailers. We suggest the RED size for the large brackets and the YELLOW for the small. If you can locate the wooden down beams in the wall, this is also excellent point to fix the brackets to using standard wood screws ( use screws at least 1 1/2 inch long). The above are only recommendations, but the overall responsibility for fixing the brackets lies with you. We cannot accept responsibility for the fitting of the brackets. You can also use our clothes airer brackets as normal shelf brackets as well. SOLD IN SINGLES. Pulleys are NOT included. These are provided with the clothes airer sets or can be purchased separately. Length: Small 280mm - Large 460mm Width: Small 20mm (Flanges 41mm)- Large 25mm (Flanges 52mm) Height: Small 195mm - Large 330mm Bolt Size: M6 Notes: Small size for 3 and 4 Latch Clothes Airers Large size for 5, 6 and 7 Lath Clothes Airers