Supplies: 1/8” outer diam. clear plastic tubing (JAR-JAF Miniatures item # R-194), Tiny candy balls (railroad fruit, no-hole beads or candy sprinkles – must fit inside the tubes), 5 mm white pom pom, 5 mm plastic flat back rhinestone, 5 mm round punch from black sequin or thin plastic (I used part of a wiggle eye), 1/8” round punched piece of fun foam, tiny black no hole beads, orange thread. Snowman Candy Tube – cut a 18 mm length of the plastic tube using an X-acto (rolling it while cutting). Smooth cut end if necessary with a file or emery board. Glue the rhinestone to the bottom as a base (see top photo). Fill with the tiny candy balls. Glue the pom pom to the top. For the hat, use the tiny punch from fun foam on top of the black 5mm disk. Glue these to the white pom pom. Glue black no-hole beads for eyes. For the nose I used two tiny snips of orange thread (for a carrot). I kind of twisted them together at one end to make a point. Santa Candy Tube – For this one I used a slice of a Fimo cane (a thick slice) that was about ¼” diameter for the top. It had a Santa face design. I used metallic no-hole beads for the ‘candy’. Candy Cards – these were made using various scrapbook stickers (Jolees, etc) in small shapes like Christmas socks, Christmas bulbs, etc. The plastic bubbles were either pill blisters or wiggle eyes with the back sliced off. Fill with purchased Fimo candy (or buy the canes and slice them yourself). Finished side of stall with candy cards: Below is another pic of the candy cards and candy tubes. Stockings - The red and white stocking above was an early miniature purchase from 1986 (artisan unknown but I recorded that I paid $6 for it). The other two stockings were bought in a lot on Ebay and were made by Lori Ann Potts of Mustard Seed Miniatures. They originally were hand sewn (red tulle netting, I think) around the edges and contained only Fimo candy. I embellished them to add the Santa and Angel figures, the red & white trim around the edges and the labels. Here is how I did the red and white trim (below). I bought the green ribbon at Christmas time from Hobby Lobby. I trimmed off the tiny candy cane edge trim and glued it around the sock. I had to notch it around the toe so it would fit the curve. I made a card on the top from just a clipping from a wrapping paper catalog (Container Store). Next time I will show finished photos of the entire project and give sources for some of the items.