Um einen Ärmel zu konstruieren müsst ihr den Armlochumfang von Schnitt des Vorderteils sowie des Rückteils messen und addieren. Das ist euer Armlochumfang (AlU) A = 1/3 Armdurchmesser Armlochhöhe messen wie in der Abbildung und addieren. A = AlU:2 - 0 bis 1cm B = Armkugelhöhe (die berechnet ihr folgendermaßen: AlH:3 - 0 bis 2cm) C = Ärmellänge D = Saumweite (Handgelenk messen, bzw. messen wie locker der Ärmel sitzen soll. Beachtet, dass ihr den Ärmel über die Hand bekommen müsst) Die oberen Linien in 4tel einteilen und den Ärmel an den Seiten je 1cm einstellen. Die roten Linien von links nach rechts folgendermaßen einzeichnen: 1. 0,8cm nach unten 2. 0,5cm nach oben 3. 1,5cm nach oben 4. 2cm nach oben 5. 1,5cm nach oben 6. Schnittpunkt Fertig :) Ärmelpunkte markieren: Als erstes müsst ihr den Ärmelpunkt bestimmen. Das macht ihr an eurem Oberteil-Grundschnitt, so wie es die Zeichnung vorgibt. Hierbei sind: A = 1/4 Armdurchmesser B = Die Strecke von der Horizontalen bis zur Schulter im Abstand von 1,5cm vom Armausschnitt C = 1/4*B Den vorderen Ärmelpunkt (vÄp) und den hinteren Ärmelpunkt (hÄp) einzeichnen. Die Ärmelpunkte einfach durch Anlegen des Ärmelschnitts auf den Ärmel übertragen.